dry heat sterilizer temperature
Site conditions before device selection.
Where dry heat sterilizer temperature has to be restated
Temperature is a protocol value, not a marketing grade. A buyer who writes only “high heat” will receive ovens that cannot be compared. Ask each factory to restate the setpoint in °C and the hold in minutes against the same load mass. Room class, steam exclusion and electrical supply stay on the same row.
| Application | Medical-device condition | Environment | Confirm |
|---|---|---|---|
| Dental instrument rooms | Moisture-sensitive handpieces; dry heat rather than steam | Bench installation, often near a sink but not a washdown cabinet | Setpoint °C, hold min, chamber L, 120 V or 230 V supply |
| Laboratory glass and powders | Loads that cannot tolerate condensate | Indoor lab bench or under-counter placement | Uniformity method, shelf count, maximum load mass |
| Cleanroom support rooms | Placement beside ISO class 5 or ISO class 7 work | Controlled air, sometimes HEPA exhaust required | Room class, exhaust type, heat rejection to HVAC |
Conditions that change the quote before the model name
Indoor clinic benches
- Environment
- Occupied room, limited heat rejection
- Confirm
- Cabinet footprint, door swing and supply voltage
Shared CSSD corridors
- Environment
- Steam autoclaves nearby; mixed-method risk
- Confirm
- That the priced line is dry heat, not autoclave class B
New versus refurbished capital
- Environment
- Budget programs sometimes allow documented refurbishment
- Confirm
- Condition as an explicit RFQ field, not a silent default
Home retail dry-heat boxes and clinical ovens can share root words. This site only accepts business-buyer briefs. Clinical specification and home DME reimbursement are different purchase paths; do not send a consumer listing as if it were a hospital protocol.
Temperature uniformity is another split that buyers leave blank. A factory may quote a setpoint while the load mass at the centre of a packed chamber never reaches that value. Ask the offer to name the measurement method and the load used for the claim. If the method is missing, treat the number as a control setting, not as proof of sterilisation inside the load.
Dental groups often reuse a 160 °C or 170 °C protocol written years earlier. That history is useful, but it is still a buyer document. We will not invent a substitute cycle. Laboratory buyers packing powders or glassware should state maximum load mass per shelf. Cleanroom buyers should state whether HEPA exhaust is required and whether the cabinet sits in an ISO class 5 or ISO class 7 room. Room class does not replace cycle data.
When steam autoclaves already occupy the same corridor, write that fact. Mixed-method rooms are where autoclave class B language leaks onto a dry-heat request. We will send the request back if the method is still ambiguous. ml/h, psi and BIPAP settings are not part of this family and should stay on their own sites.